1, Our carbon molecular sieve with have high strength, suitable water and oil resistance..

  China Carbon Molecular Sieve Co., Ltd. uses pure raw materials that has not inorganic salt ash, advanced hole adjustment technology, advanced grinding and coating processes to produce carbon Molecular Sieve with long service life, high nitrogen yield and low air consumption.

    People hope that carbon molecular sieve has high nitrogen yield, long service life and low raw gas consumption. In order to increase the nitrogen yield, the diameter of the carbon molecular sieve(CMS) is reduced. People make carbon molecular sieve with a diameter of less than 1.1mm. However, in the process of using carbon molecules (CMS), if the oil and water in the air enter the carbon molecular sieve, the carbon molecular sieve (CMS) absorbs water and oil, which will gradually reduce the nitrogen yield and service life of the carbon molecular sieve and the nitrogen generator. In addition, the flushing of the airflow will cause The pulverization of carbon molecular sieve will also reduce the nitrogen yield and service life of the nitrogen generator. Therefore, the carbon molecular sieve(CMS) must be vibrated and compacted when it is loaded into the adsorption tower of the nitrogen generator. In the process of use, the air entering the carbon molecular sieve in the adsorption tower of the nitrogen generator is usually first dried and purified to control the oil in the air. And the water content is below 3ppm.
The carbon molecular sieves with small diameters have lower strength than carbon molecular sieves with large diameters, So,small diameters carbon molecular sieve have a shorter service life.
China Carbon Molecular Sieve Co., Ltd. found that increasing the nitrogen yield of carbon molecular sieves can also be achieved by selecting appropriate pure raw materials. The lower the ash content of inorganic salts in the raw materials for carbon molecular sieves, especially sodium ions The smaller the content, the higher the nitrogen yield, water resistance and oil resistance of the carbon molecular sieve, and the longer the service life. Secondly, the raw material powder should be crushed and ground to less than 3 microns. The finer the raw material powder, the higher the strength of the carbon molecular sieve (CMS). The higher the nitrogen production rate and the higher the water and oil resistance of the carbon molecular sieve, the longer the service life. Therefore, the nitrogen yield of our carbon molecular sieve with a diameter of 1.2-1.8mm is the same as that of a carbon molecular sieve with a diameter of less than 1.1mm, but the strength of the carbon molecular sieve (CMS)is greatly improved and the service life is long.
Finally, China Carbon Molecular Sieve Co., Ltd. adopted a suitable coating process to improve the water resistance and oil resistance of the carbon molecular sieve (CMS) and increase the service life of the carbon molecular sieve.

.